NEC Univerge SV8100 - Page 777

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 753
20-14-09 Class of Service Options for
DISA/E&M – Forced Trunk
Disconnect <Not for ISDN
T-point>
This option Enables or Disables a
tie trunk caller’s ability to use
Forced Trunk Disconnect (Service
Code 26). This option is not
available to DISA callers.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-14-10 Class of Service Options for
DISA/E&M – Call Forward Setting
by Remote via DISA
Enable or Disable a DISA callers
ability to use the Call Forward
service codes (Program 11-11-01
through Program 11-11-05).
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-14-11 Class of Service Options for
DISA/E&M – DISA/Tie Trunk
Barge-In
In an extension Class of Service,
enable (1) or disable (0) a DISA or
tie trunk user from using the
Barge-In feature.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-14-12 Class of Service Options for
DISA/E&M – Retrieve Park Hold
Turns Off or On the ability for a
DISA caller to retrieve parked or
held calls.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
21-05-01 Toll Restriction Class –
International Call Restriction
Table
For the Toll Restriction Class you
select, assigned (1) or unassigned
(0) the International Call Restrict
Table (Program 21-06-01).
0 = Unassigned (No)
1 = Assigned (Yes)
default:
1, 6~15 = 0
2~5 = 1
3
21-05-02 Toll Restriction Class –
International Call Permit Code
Table
For the Toll Restriction Class you
select, assigned (1) or unassigned
(0) the International Call Permit
Table (Program 21-06-02).
0 = Unassigned
1 = Assigned
default:
1, 3~15 = 0
2 = 1
3
21-05-04 Toll Restriction Class –
Maximum Number of Digits
Table Assignment
Select the table (defined in
Program 21-06-03) to be used to
determine the maximum number
of digits allowed for outgoing calls.
1~4 =Table
0 =Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
3
21-05-05 Toll Restriction Class – Common
Permit Code Table
It chooses whether the table set
up by Program 21-06-04 is
referred to, or not referred to.
0 = Unassigned
1 = Assigned
Default:
1, 8~15 = 0
2~7 = 1
3
21-05-06 Toll Restriction Class – Common
Restriction Table
It chooses whether the table set
up by Program 21-06-05 is
referred to, or not referred to.
0 = Unassigned
1 = Assigned
Default:
1, 6~15 = 0
2~5 = 1
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3