NEC Univerge SV8100 - Page 778

Issue 1.0 UNIVERGE SV8100
2 - 754 Multiple Trunk Types
21-05-07 Toll Restriction Class – Permit
Code Table
Set the tables 1~4 when referring
to the table set up by Program
21-06-06.
1~4 =Table
0 = Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
3
21-05-08 Toll Restriction Class –
Restriction Table
Set the tables 1~4 when referring
to the table set up by Program
21-06-07.
1~4 =Table
0 = Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
3
21-05-09 Toll Restriction Class –
Restriction for Common Speed
Dials
For the Code Restriction Class
you select, enable (1) or disable
(0) Code Restriction for Common
Speed Dialing numbers.
0 = Does Not Restrict
1 = Following Restriction
Check
(default =0)
3
21-05-10 Toll Restriction Class –
Restriction for Group Speed
Dials
For the Toll Restriction Class you
select, enable (1) or disable (0)
Code Restriction for Group Speed
Dialing numbers.
0 = Does Not Restrict
1 = Following Restriction
Check
(default =0)
3
21-05-11 Toll Restriction Class – Intercom
Call Restriction
For the Toll Restriction Class you
select, enable (1) or disable (0)
Intercom Call Restriction. If
enabled, extensions cannot place
or receive Intercom calls.
0 = Disable
1 = Enable
(default = 0)
3
21-05-12 Toll Restriction Class – PBX Call
Restriction
If Program 34-01-05 is set to (1),
define the toll restriction settings
for Tie Lines.
1~4 =Table
0 = Disable (None)
Default:
1~6, 8~15 = 0
7 = 1
3
21-05-13 Toll Restriction Class –
Restriction of Tie Line Calls
Enable (1) or disable (0) toll
restriction for Tie Line calls
(defined in Program 34-08-01).
0 = Disable
1 = Enable
(default = 0)
3
22-02-01 Incoming Call Trunk Setup For each Night Service mode,
enter service type 5 when the
trunk should be a tie trunk.
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3