NEC Univerge SV8100 - Page 813

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 789
Operation
To send Off-Hook signals to an extension busy on a call:

Your extension may send off-hook signals automatically.
1. Dial 7.
- OR -
Press Off-Hook Signaling key (Program 15-07 or SC 751: 33).
 You hear ringback.
 To have your call voice-announce, dial 1.
Receiving Off-Hook Signaling on a single line telephone while engaged on an internal or external
call:
1. When Off-Hook Signaling is heard in the receiver, press the Flash Key to answer the call. The first
call is placed on hold.
2. Press the Flash Key again to toggle between the two calls.
 If the single line phone hangs up with the active call, the other call on hold rings back to the single line.
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
automatically (1) or manually (0)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-34 Class of Service Options
(Supplementary Service) – Block
Manual Off-Hook Signaling
Turns Off (0) or On (1) an extension
ability to block off-hook signals
manually sent from a co-worker.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-18-06 Service Tone Timers – Interval of
Call Waiting Tone
Use this timer to set the time
between Off-Hook Signaling alerts.
0~64800 (seconds)
(default = 10 seconds)
3
80-01-01
(39)
Service Tone Setup – Repeat
Count
Customize the system basic tones
and system service tones. You
need to reset for the changes to
take affect.
0~255 (default 0 = until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
3
80-01-02
(39)
Service Tone Setup – Basic Tone
Number
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the chassis
must be reset for the changes to
take effect.
 Call Screening
 Call Holding
 Busy Greeting
 Await Answer Transfer
Refer to Table 2-15
Service Tone Setup,
Program 80-01-02 on
page 2-558
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3