NEC Univerge SV8100 - Page 818

Issue 1.0 UNIVERGE SV8100
2 - 794 One-Touch Calling
For Personal Speed Dial:
a. Dial the general trunk access code (0).
- OR -
Dial the Specific Trunk Service Code (
#0) plus the trunk number (e.g., 005).
- OR -
Dial the Trunk Group Service Code (704) plus the trunk group number (e.g., 1).
b. Dial the number you want to store.
 The total of the digits stored in steps 3 and 4 cannot exceed 24.
 Valid entries are 0~9, # and . To enter a pause, press MIC. To store a Flash, press Redial.
c. Press Hold.
d. Press Speaker.
For Speed Dial – System/Group:
a. Dial
#2 to store a Speed Dial – System dialing number.
- OR -
Dial #4 to store a Speed Dial – Group dialing number.
b. Dial Speed Dial number storage code (e.g., 001).
c. Press Hold.
d. Press Speaker.
For Central Office Calls, Placing (Trunk Calling):
a. a. Dial the general trunk access code (0).
- OR -
Dial the specific Trunk Service Code (#0) plus the trunk number (e.g., 005).
- OR -
Dial the Trunk Group Service Code (704) plus the trunk group number (e.g., 1).
b. Dial the telephone number to be stored.
c. Press Hold.
d. Press Speaker.
For Service Codes:
a. Dial the Service Code you want stored.
 For example, if you want a One-Touch Key to automatically clear your Last Number Redial, enter 776.
b. Press Hold.
c. Press Speaker.