NEC Univerge SV8100 - Page 825

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 801
15-03-06 Single Line Telephone Basic
Data Setup – Extension Polarity
Reverse
-- Not Used in U.S. -- Do Not
Change Default Entry as DTMF
issues may arise with voice mail.
0 = Disable (Off)
1 = Enable (On)
(default = 0)
3
15-03-07 Single Line Telephone Basic
Data Setup – Enabled On-Hook
When Holding (SLT)
Used to Enable or Disable Enabled
On-Hook When Holding for SLT.
0 = No
1 = Yes
(default = 1)
3
15-03-08 Single Line Telephone Basic
Data Setup – Answer On-Hook
when Holding (SLT)
Used to Enable or Disable Answer
On-Hook when Holding for SLT.
0 = Disable
(No)
1 = Yes
(Enable)
(default = 1)
3
15-03-09 Single Line Telephone Basic
Data Setup – Caller ID Function -
For External Module
Enable (1) or disable (0) the Caller
ID FSK signal for an external Caller
ID module or a 3rd party vendor
telephone with Caller ID display.
Important:
If voice mail is used, this setting
must be disabled for the system
integration codes to be correct.
 With a 2500 set (no Caller ID)
installed, this must be set to 0
for incoming callers to have a
talk path.
0 = Disable
1 = Enable
(default = 0)
3
15-03-10 Single Line Telephone Basic
Data Setup – Caller ID Name
Determine if an extension user
telephone should display the Caller
ID name.
0 = Disable
1 = Enable
(default = 1)
3
15-03-11 Single Line Telephone Basic
Data Setup – Caller ID Type
Determine whether the Caller ID
type is FSK or DTMF.
0 = FSK
1 = DTMF
(default = 0)
3
15-03-14 Single Line Telephone Basic
Data Setup – Forwarded Caller ID
Display Mode
Determine what the display shows
when a multiline terminal receives
a forwarded outside call.
0 = Calling Extension
Number (Calling)
1 = External Caller ID
(Forward)
(default = 0)
3
20-03-01 System Options for Single Line
Telephones – SLT Call Waiting
Answer Mode
For a busy single line (500/2500
type) telephone, set the mode used
to answer a camped-on trunk call.
For ESL sets, enabling this option
(1) allows the user to dial Service
Code for Voice Mail Conversation
Record.
0 = Hookflash (Hooking)
1 = Hookflash + Service
Code 654
(default = 0)
3
20-03-02 System Options for Single Line
Telephones – Ignore Received
DP Dial on DTMF SLT Port
Use this option to define whether
the system should receive dial
pulse and DTMF signals (0) or
ignore dial pulse and only accept
DTMF signals (1).
0 = Do Not Ignore (No)
1 = Ignore (Yes)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3