NEC Univerge SV8100 - Page 826

Issue 1.0 UNIVERGE SV8100
2 - 802 (OPX) Off-Premise Extension
20-03-03 System Options for Single Line
Telephones – SLT DTMF Dial to
Trunk Lines
 Type 0: The system keeps the
digits dialed by the single line
telephone on a trunk in a buffer.
After all the digits are received,
the system sends all the digits
to the trunk. If the time space
between digits is longer than
the time in Item 4, the system
considers all digits received.
 Type 1: The system passes the
received digits from the single
line telephone to the trunk
immediately. If the single line
telephone has a Last Number
Dial key without a pause, this
key may not be able to use the
Last Number Dial key with the
Type 1 setting.
When using a third-party external
paging device, set this option to 1.
In addition, set Program 20-03-04
to 1. These programs must be set
for Wireless DECT (SIP) users to
break dial tone on an analog trunk
that is used for paging.
0 = Receive all dialed
data, before sending (All)
1 = Direct through out
(Direct)
(default = 0)
3
20-03-04 System Options for Single Line
Telephones – Dial Sending Start
Time for SLT or ARS
When ARS or an analog extension
user accesses a trunk and dials an
outside call, the system waits this
interval before outdialing the first
digit (0~64800 seconds).
0~64800 (seconds)
(default = 1 second)
3
20-03-05 System Options for Single Line
Telephones – SLT Operation
Mode
Used to set the operation mode for
SLT terminals.
0 = Normal Mode
1 = Extended Mode1
2 = Extended Mode2
(default = 0)
3
20-03-06 System Options for Single Line
Telephones – Headset Ringing
Start Time (for SLT)
Define the headset ringing start
time. After this time expires from
the time when a single line
telephone is off-hook, the system
sets the single line telephone to
headset ringing mode.
0~64800 seconds
(default = 5)
3
20-03-07 System Options for Single Line
Telephones – Trunk Call Dial
Forced Sending Start Time
(Forced Dial)
Used to define the Trunk Call Dial
Forced Sending Start Time
(Forced Dial) for single line
telephones.
0~64800 seconds
(default = 0)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port =
Class 1
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3