NEC Univerge SV8100 - Page 851

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 827
Flash
Pulse to Tone Conversion
Ring Groups
Speed Dial – System/Group/Station
Trunk Group Routing
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-01-01 Basic Trunk Data Setup – Trunk
Name
Set the names for trunks. The trunk
name displays on a multiline
terminal for incoming and outgoing
calls.
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200
3
14-01-02 Basic Trunk Data Setup –
Transmit Level
Set these options for compatibility
with the connected PBX.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
3
14-01-08 Basic Trunk Data Setup – Toll
Restriction
For each PBX trunk port, enable (0)
or disable (1) Toll Restriction.
0 = Restriction Disabled
(No)
1 = Restriction Enabled
(Yes)
(default = 1)
3
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
At default, Program 14-02-01 is set
to 2 (DTMF).
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
3
14-02-02 Analog Trunk Data Setup – Ring
Detect Type
This option sets Extended Ring
Detect or Immediate Ring Detect
for the trunk. For T1 loop/ground
start trunks, this option must be set
to 1 for the trunks to ring and light
correctly.
Trunks 1~200
0 = Normal/delayed
1 = Immediate Ringing
(default = 1)
3