NEC Univerge SV8100 - Page 852

Issue 1.0 UNIVERGE SV8100
2 - 828 PBX Compatibility
Operation
To place a call over a PBX trunk:
1. At multiline terminal, press Speaker and dial 704.
- OR -
At single line telephone, lift the handset and dial 704.
2. Dial PBX trunk group number (1~9 or 001~100).
3. Dial PBX access code and number.
- OR -
1. At the multiline terminal only, press PBX trunk group key (Program 15-07 or SC 752: 02 + group).
2. Dial PBX access code and number.
- OR -
1. At the multiline terminal, press Speaker and dial 0.
- OR -
At the single line telephone, lift the handset and dial 0.
14-04-01 Behind PBX Setup For each PBX trunk port, enter 1.
You make a separate entry for each
Night Service mode.
0 = Stand Alone (Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
3
21-04-01 Toll Restriction Class for
Extensions
Assign a Toll Restriction Class
(1~15) to each extension.
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
3
21-05-12 Toll Restriction Class – PBX Call
Restriction
For each Toll Restriction Class,
enter 1 to restrict calls on the PBX
trunk to outside calls only. Enter 0
to allow users to dial PBX
extensions.
1~4 =Table
0 = Disable (None)
Default:
1~6, 8~15 = 0
7 = 1
3
21-06-08 Toll Restriction Table Data Setup
– PBX Access Code
Enter the system PBX access
codes. The system can have up to
four groups of codes. A code can
have one or two digits. Valid
entries are 0~9,
# and . Use Line
Key 1 as a don’t care digit. If using
Account Codes, do not use the  in
the PBX Access Code.
Dial (Up to two digits)
default:
Table 1~4 = No Setting
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3