NEC Univerge SV8100 - Page 861

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 837
11-15-14 Service Code Setup,
Administrative (for Special
Access) – Modem Access
Assign the service code to be used
to access the internal modem on the
CD-CP00-AU.
(default = 740)
3
22-02-01 Incoming Call Trunk Setup Define the service type for the trunk
intended to access the internal
modem as 4:DIL.
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-07-01 DIL Assignment Assign the Modem Access service
code set in Program 11-15-14 as
the destination extension for the DIL
trunk for modem access.
Extension Number
(maximum eight digits)
(default not assigned)
3
90-02-01 Programming Password Setup –
User Name
Use to set the system passwords. Maximum 10 characters
User No. 1, Level 1 (MF)
User Name = nec-i,
Password = 374772
User No. 2, Level 2 (IN)
User Name = tech,
Password = 12345678
User No. 3, Level 3 (SA)
User Name = admin1,
Password = 0000
User No. 4, Level 4 (SB)
User Name = admin2,
Password = 9999
3
90-02-02 Programming Password Setup –
Password
Configure the administrator
accounts that are used when
connecting to the KTS via PCPro/
WebPro.
If using PCPro, these are the
accounts that are used to connect.
If using WebPro, these are the
accounts that are used to login.
 If calls are answered by an
Auto attendant first, instead of
the DIL setup on Program
22-01 and PRG 22-07, set the
transfer destination in the Auto
Attendant to the Modem
Access Service Code.
Up to eight digits.
Refer to the SV8100
Programming Manual for
default settings.
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3