Issue 1.0 UNIVERGE SV8100
2 - 848 Prime Line Selection
Related Features
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward Line (DIL)
Direct Inward System Access (DISA)
Line Preference
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-05-01 Trunk Group – Trunk Group
Number
Assign Prime Line to a separate
trunk group for outgoing Prime Line
selection. (Also refer to Program
14-06 and Program 21-02.)
Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order.)
3
14-06-01 Trunk Group Routing – Priority
Order Number
Used to set the priority order
number 1~4.
0 = Not Specify1~100 :
(Trunk Group
Number)1001~1100 :
(1000 + Route Table
Number)
Default:
Route 1, Order Number 1
= 1 (Trunk Group 1)
Order Numbers 2, 3, 4 =
0 (Not Specified)
All Other Routes (2~100)
and Order Numbers
(1~4) = 0 (Not Specified)
3
To Next Page
Loading...
