Issue 1.0 UNIVERGE SV8100
2 - 904 Save Number Dialed
Related Features
Automatic Route Selection
Central Office Calls, Placing
Dial Tone Detection
Last Number Redial
Programmable Function Keys
Repeat Redial
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-13 Service Code Setup (for Service
Access) – Saved Number Dial
Customize the service code to be
used for dialing a saved number.
MLT, SLT
(default = 715)
3
11-12-18 Service Code Setup (for Service
Access) – Clear Saved Number
Dialing Data
Define the service code for Clear
Save Number Dialing List if it is not
acceptable.
MLT, SLT
(default = 785)
3
15-07-01 Programmable Function Keys Assign a function key as a Save
key (code 30).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
00 ~
99 (Appearance
Function Code) (Service
Code 752 by default)
3
To Next Page
Loading...
