NEC Univerge SV8100 - Page 986

Issue 1.0 UNIVERGE SV8100
2 - 962 Speed Dial – System/Group/Station
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-09-01 DTMF and Dial Tone Circuit Setup If dial tone detection is enabled, be
sure to allocate at least one circuit
for dial tone detection (Type 0 or 2).
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource 97~160
= 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
3
11-10-04 Service Code Setup (for System
Administrator) – Storing Common
Speed Dialing Numbers
Used to customize the service code
used for storing Common Speed
Dialing Numbers.
MLT
(default = 753)
3
11-10-05 Service Code Setup (for System
Administrator) – Storing Group
Speed Dialing Numbers
Used to customize the service code
used for storing group speed dialing
numbers.
MLT
(default = 754)
3
11-11-39 Service Code Setup (for Setup/
Entry Operation) – Station Speed
Dial Number Entry
Used to customize the service code
used for entering station speed dial
numbers.
MLT, SLT
(default = 755)
3
11-12-10 Service Code Setup (for Service
Access) – Station Speed Dialing
Assign Service code for accessing
System Speed Dial bins (default
#2).
MLT, SLT
(default =
#2)
3
11-12-11 Service Code Setup (for Service
Access) – Group Speed Dialing
Used to customize the service code
for group speed dialing.
MLT, SLT
(default =
#4)
3
13-01-01 Speed Dialing Option Setup –
Speed Dialing Auto Outgoing Call
Mode
Designate trunk or intercom
outgoing mode, (default: 0, trunk).
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
3
13-01-03 Speed Dialing Option Setup –
Number of Common Speed Dialing
Bins
Designate the bins the system uses
for System Speed Dialing.
0~2000
0 = No Common Speed
Dialing
(default = 1000)
3
13-02-01 Group Speed Dialing Bins Designates the starting bin number
the system uses for Group Speed
Dialing.
01~64
(default not assigned)
3