NEC Univerge SV8100 - Page 987

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 963
13-03-01 Speed Dialing Group Assignment
for Extensions
For Group Speed Dialing, assign
extensions to Speed Dialing groups
(1~64).
01~64
(default = 1)
3
13-04-01 Speed Dialing Number and Name –
Speed Dialing Data
Enter the System and Group Speed
Dialing numbers and names.
1~9, 0, , #
Pause (Press line key 1)
Recall/Flash (Press line
key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
3
13-04-02 Speed Dialing Number and Name –
Name
Assign a name to each System
Speed Dial bin.
Maximum 12 Characters
(Use dial pad to enter
name)
(default not assigned)
3
13-04-03 Speed Dialing Number and Name –
Transfer Mode
When the incoming caller ID
matches the number programmed in
the speed dial bin, this setting
determines the destination of the
call.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring Group
(IRG)
(default = 0)
3
13-04-04 Speed Dialing Number and Name –
Transfer Destination Number
When the incoming caller ID
matches the number programmed in
the speed dial bin, this setting
determines the destination of the
call.
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
1~9, 0, ,
#, P, R, @
(Maximum 24
Characters)
2 = Incoming Ring Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
3
13-04-05 Speed Dialing Number and Name –
Incoming Ring Pattern
Define the ring tone for the caller ID
routed call.
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern
(1~4)
5 ~ 9 = Scale Pattern
(1~5)
(default = 0)
3
13-05-01 Speed Dialing Trunk Group –
Trunk Group Number
For each System Speed Dialing
number, enter the routing option
Trunk Group Number (1~100) to dial
out on.
0~100
(default not assigned)
3
14-02-06 Analog Trunk Data Setup – Pause
at 1st digit after Line Seize in
Manual Dial Mode
Enable/disable the system ability to
pause after dialing the first digit.
0 = No Pause (No)
1 = Pause (Yes)
(default = 1)
3
15-02-04 Multiline Telephone Basic Data
setup – Redial (Speed Dial )
Control
Assign the extension Redial key for
either Common (0) or Group (1)
Speed Dialing.
0 = Common and
Individual Speed Dialing
1 = Group Speed Dialing
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3