Chapter 5 System Data Mode
5-3 NWA-033628-001 Rev.1.0
Using System Data Mode
Using System Data Mode
Configuring System Data
Follow instructions below to configure system data in System Data Mode.
STEP1: Click submenu in System Data Mode to expand the tree and then click the command you
want to configure.
A screen is displayed for configuring the selected command.
NOTE: Items marked by / will not invoke a setup screen when they are clicked.
STEP2: Click the [Read] button.
If a number is available that serves as a key, such as CM12 or 18, enter it and click the [Read]
button.
NOTE: When clicking the [Read] button on the [System Data] screen, the reading out data is stored in
the install folder as the script files. This script files can be re-used by Scripts ( Page 4-66 ).
<install folder>\pbxfiles\system data\<Name of Connection Accounts>
To Next Page
Loading...
