Chapter 6 Command Mode
6-7 NWA-033628-001 Rev.1.0
Using Command Mode
STEP7: To view second data with the previous YY number, enter [-YY].
• Classic Mode : [F10] key
• Standard Mode : [F7] key
• Enter Mode : [F10] key
Second data with the previous YY number is displayed.
<Writing System Data (Second Data)>
STEP1: Enter [ST].
• Classic Mode : [/] key
• Standard Mode : [F9] key
• Enter Mode : [Esc] key
STEP2: Enter a command and then enter [DE].
• Classic Mode : Command + [Space] key
• Standard Mode : Command + [F8] key
• Enter Mode : Command + [Enter] key
STEP3: Enter first data and then enter [DE].
• Classic Mode : First data + [Space] key
• Standard Mode : First data + [F8] key
• Enter Mode : First data + [Enter] key
The second data is displayed.
STEP4: Second data and then enter [EXE].
• Classic Mode : Second data + [.] key
• Standard Mode : Second data + [F2] key
• Enter Mode : Second data + [Enter] key
System data (second data) has now been written to the SV8300.
NOTE: In Classic Mode, “CCC” cannot be entered as second data. Use Standard Mode when it is nec-
essary to enter “CCC” as second data.
* In Classic Mode, “CCC” is used to reset second data to its default.
To Next Page
Loading...
