EasyManua.ls Logo

NEC Univerge SV8300 - Page 219

NEC Univerge SV8300
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix C Troubleshooting
C-7 NWA-033628-001 Rev.1.0
Continued on next page
Error Message Cause Remedial action
The Trunk Number xx has
already been registered.
The specified trunk number is
already registered. Take either of
the following actions as appro-
priate:
1. Modify the trunk information.
2. Delete the trunk number once
and then register it again.
The Trunk Number xx is not reg-
istered.
Register a trunk number first.
The Station Number xx has
already been registered.
The specified extension number
is already registered. Take either
of the following actions as appro-
priate:
1. Modify the station number
information.
2. Delete the station number
once and then register it again.
The Station Number xx is not
registered.
Register an station number first.
First, read the data. Read data before writing it.
Cannot start up because that the
file could not be found or was
broken.
Reinstall the SV8300 PCPro.
Reinstall SV8300 PCPro.
Cannot start up because the
desired file is used in the other
application.
–Retry.
The file could not be found. Specify a valid folder or browse
a valid file.
Failed to update the file. Check to see if the file is not
read-only or if it is not used by
another application.

Table of Contents

Other manuals for NEC Univerge SV8300

Related product manuals