38
PROGRAMMING
NESS D8 (V4.7) CONTROL PANEL – INSTALLER MANUAL
TELEPHONE NUMBERS 1 & 2
The D8 can dial up to 2 phone numbers when an event is to be transmitted to a
remote location. Telephone numbers may be up to 15 digits long.
PROGRAMMING SEQUENCE:
P70E existing telephone number is displayed
[ENTER NEW TELEPHONE No] E new telephone number is displayed
EXAMPLE: To program Telephone No.1 to be 03 1234 1234:
P70E0312341234E
P70E, P71E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
No telephone numbers
NOTES:
• If telephone number 2 is disabled, all calls
are made on telephone number 1 and the
setting of P87E 1E has no effect.
• If telephone number 3 is disabled, all test
calls are made on telephone number 1&2
• Any keypress will stop the telephone
number display sequence
• RELATED OPTIONS:
P87E 1E Alternate Primary/Secondary
telephone numbers
P86E 1E Disable dialler (still allows
remote up/download if programmed)
OPTION No DESCRIPTION FACTORY DEFAULT
P70E Telephone Number 1 - Primary none
P71E Telephone Number 2 - Secondary none
P80E Telephone Number 3 - Test Calls none
P81E Telephone Number 4 - Callback for Up/download none
P00E Follow Me Telephone Number - For Audible Dialling none
OPTION No DESCRIPTION FACTORY DEFAULT
P72E Account Number 1 0000
P73E Account Number 2 0000
ACCOUNT NUMBER 1 & 2
Account numbers for identifying the panel to the Central Station. Area 1 Open/
Close reports will report on Account No.1 and Area 2 Open/Close reports will
report on Account No.2.
Zone Alarms can be assigned to report on either Account Number as set by
Option P79E.
All miscellaneous events (eg. Tampers, Mains Fail) will report on Account No. 1.
PROGRAMMING SEQUENCE:
P72E (or P73E) existing account number is displayed
[ENTER NEW ACCOUNT No] E new account number is displayed
EXAMPLE: To program Account No.1 to be 1239:
P72E1239E
P72E, P73E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
P72E Account No.1: 0000
P73E Account No.2: 0000
NOTES:
• RELATED OPTIONS:
P79E Account No.2 zones
Also see page 39, Hex Client Codes
TO CLEAR A TELEPHONE NUMBER
To clear a telephone number, enter the MEMORY key in place of the
telephone number. Example, to clear a Telephone Number 1 press: P70E
MEMORY E
SPECIAL CHARACTERS (Applies to all telephone Numbers)
Pauses, * (star) or # (hash) (VF digits) can be included in the dialling
sequence by using the keys in the table below.
SPECIAL CHARACTER KEY ENTRY DISPLAYED ON LCD DISPLAY
PAUSE (1.6sec) ARM Key 12
* (Star) MONITOR Key 10
# (Hash) EXCLUDE Key 11
SPECIAL FUNCTIONS FOR ALL TELEPHONE NUMBERS
To Next Page
Loading...
Need help?
General
