Command with FXS Gateway
- 184 -
-gwtype: Gateway type has two kinds, gateway and terminal. Gateway type: will
register as H.323 defined Gateway; user has to define [prefix] in next
command. Terminal type: will register as H.323 defined Terminal, [prefix]
command is not necessary.
-dfgw: Default gateway is applied under Peer-to-Peer mode. User defines a constant
default gateway IP address, then any number dialed will pass forward to this
IP Address.
-prefix: Assign VoIP Gateway prefix number, as well as the registered number on the
Gatekeeper.
-line1: Assign line 1 number.
-line2: Assign line 2 number.
-line3: Assign line 3 number.
-line4: Assign line 4 number.
Note:
Line number follow Gateway port number display, if you use FXS-02
Gateway you can only setup line1 & line2 number.
User can also set “x” in line number to disable the port. If the port is disabled,
it can only receive calls but not calling out.
Line1 & line2 number must follow the prefix number if device is configured as
To Next Page
Loading...
