NETGEAR DGND3800B

Virtual Private Networking
115
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
Note: The LAN IP address ranges of each VPN endpoint has to be
different. The connection fails if both are using the NETGEAR
default address range of 192.168.0.x.
 To configure a gateway-to-gateway VPN tunnel using the VPN Wizard:
1. Log in to Gateway A on LAN A. Select Advanced > VPN Wizard. Click Next, and the
Step 1 of 3 screen displays.
2. Fill in the Connection Name and pre-shared key fields. Select the radio button for the type of
target endpoint, and click Next, and the Step 2 of 3 screen displays.
3. Fill in the IP address or FQDN for the target VPN endpoint WAN connection, and click Next.
and the Step 3 of 3 screen displays.
4. Fill in the IP Address and Subnet Mask fields for the target endpoint that can use this
tunnel, and click Next.