NETGEAR WAC104 - Install and Access the AP in Your Network

2
Install and Access the AP in Your
Network
This chapter describes how you can install and access the AP in your network.
The chapter contains the following sections:
• Position your AP
• Set up and connect the AP to your router
• About logging in to the local browser UI
• Connect and log in to the AP for initial configuration
• Find the IP address of the AP when you cannot use aplogin.net
• Log in to the AP after you complete the initial log-in process
• Change the language
• Set the time zone and adjust the daylight saving time
• Connect a WiFi or wired device to the AP’s network after installation
Note: In this chapter, we refer to the access point as the AP.
15