To connect a computer or LAN device to the AP with an Ethernet cable:
1. Make sure that the AP is receiving power (its Power LED is lit).
2. Connect an Ethernet cable to an Ethernet port on the computer or LAN device.
3.
Connect the other end of the Ethernet cable to one of the numbered Ethernet ports
on the AP.
You can use any of the four LAN ports on the AP.
Note: You can also connect the computer to a switch or hub that is connected to
one of the LAN ports on the .
The AP LAN LED for the port to which you attached the device lights solid green.
Your computer or LAN device connects to the local area network (LAN).
User Manual31Install and Access the AP in Your
Network
802.11ac Wireless Access Point Model WAC104
To Next Page
Loading...
