MX Series Voice Gateway User Manual
New Rock Technologies, Inc. 85
Figure 2-53 Feature Codes Configuration Interface
Table 2-32 Feature Codes Configuration Parameter
The feature code for obtaining the IP address of gateway, with a default of ##.
When this feature code is dialed, the phone will play the device IP address, the web port
number for accessing the device, the IP address of the gateway, the subnet mask, and the
system software version number.
Note: If the device has only the FXO port, you can use Finder, a tool developed by New Rock,
to obtain the IP address.
If you want to have a copy of Finder, please send an email to gs@newrocktech.com.
The feature code for obtaining the phone number of the subscriber line, with default of #00. By
dialing this key, you will hear the phone number of the subscriber line voiced by the gateway.
You can click to allow the change of the service feature codes, or deselect the checkbox
to not allow the change of the service feature code. By default, service feature codes are not
allowed to change.
The feature code for activating unconditional call forwarding, with a default of *60. Dialing
this key will activate unconditional call forward of the line and set the destination number for
call forwarding. User operation: off hook → press *60 →enter the destination number.
Users can determine the latest destination number set by dialing *60*.
Note: It is required to enable call forwarding service before using this function (please see the
instructions on the relevant configuration of subscriber line).
The feature code for deactivating unconditional call forwarding, with default of #60.
User operation: off hook → press #60 → hang up.
The feature code for activating call forwarding when the line is busy, with default of *61.
Dialing this key may activate CFB, and specify the destination number. It is required to enable
call forwarding on busy service before using this function (See 2.3.2 Subscriber Line
Features).
To Next Page
Loading...
