19 EDH0170FE1010 – 09/98
LDS1000 Controller for Laser Diode Sensors
The display is in % in relation to the nominal value established at 100%.
(F5)Return to main menu.
7.3.6 Maintenance Mode
=> (F5) => (F4) => (F2)
Here the brut value of the 4 channels of the analog/digital converter from
the sensor is displayed. Interpreting the values depends on the sensor that
is in place. Their read-out enables the sensor’s electronic offset to be cor-
rected.
(F5)Return to main menu.
7.4 Configuration Functions
Here we find the way to parameter the following elements:
•Parameter input of the sensor used.
•Parameter input of the controller.
•Interface parameter input.
7.4.1 Parameter Input of the Current Sensor or the Memorized Sensors
=> (F4) => (F1)
This mode displays the number of the current sensor (currently valid) and
provides access to the following menus:
(F1)Modification of current sensor parameters.
(F2)Visualization of current sensor parameters.
(F3)Choosing another current sensor.
(F5)Return to main menu.
7.4.1.1 Selecting the Number of the Current Sensor
=> (F4) => (F1) => (F3)
From this menu, it is possible to modify the number of the current sensor.
The display then takes into account the parameters associated with the
number of the current sensor.
(F2)Previous number (-1).
(F3)Next number (+1).
(F4)Visualization of parameters of the sensor envisaged.
(F5)Save the new configuration.
To Next Page
Loading...
Need help?
General
