NGTeco NG-MB2 - Finger Enrollment

NG-MB1/NG-MB2 User Manual
Page | 9 Copyright©2022 NGTeco. All rights reserved.
 If the glasses have been changed, authentication may fail. If the face without
glasses has been registered, authenticate the face without glasses further. If the
face with glasses has been registered, authenticate the face with the previously
worn glasses.
 If a part of the face is covered with a hat, a mask, an eye patch, or sunglasses,
authentication may fail. Do not cover the face, allow the device to recognize both
the eyebrows and the face.
2.4 Finger Enrollment
Finger Enrollment procedure includes capturing a user’s fingerprint and saving it as a
template to the corresponding User ID. To enhance the fingerprint authentication rate, make
sure you enroll the finger in a proper manner.
2.4.1 Finger Selection for Enrollment
 It is recommended to use the index finger or middle finger to enroll your fingerprint.
 If the fingerprints on your selected hand are worn or damaged, try using the other hand.
 If the fingers are small, try enrolling the thumb finger.
2.4.2 Enrollment Operation
 Place the finger flat and centered on the sensor surface.
 The score for each enrollment will be displayed. Make sure the score is high enough to
ensure proper enrollment and authentication.
 Place the finger consecutively until the success message appears. An illustration is given
below: