NG-MB1/NG-MB2 User Manual
Page | 42 Copyright©2022 NGTeco. All rights reserved.
6.3 Wi-Fi Configuration through USB
You can also configure Wi-Fi through the Wi-Fi configuration template uploaded from a USB
disk.
To configure Wi-Fi through a USB disk, perform the following steps:
1. Go to [Comm.] then [Wi-Fi Setup by USB].
2. The interface to download the template will be displayed as shown below:
3. Insert a USB drive into the device.
4. Navigate to [Download] and press <M/OK>.
To Next Page
Loading...
