NGTeco NG-MB2 - Verification Modes

To Next Page

To Previous Page

NG-MB1/NG-MB2 User Manual

2.4.3 Quality Improvement of Fingerprint Reads

 Place the finger firmly on the sensor surface.

 Always use clean fingers for enrollment.

 Do not slide the finger while enrolling it.

 Avoid angled or tilted finger positions for enrollment.

For further details, refer Fingerprint Enrollment

2.5 Verification Modes

In the device, there are four verification modes, namely:

 Fingerprint verification

 Face verification

 Card Number verification★

 Password verification

These verification modes can be used for check-in and check-out punches and access to the

Admin menu.

2.5.1 Face

The face verification can be done in two ways:

1: N Verification: In this verification mode, the device compares the collected facial images

with all face data registered in the device. The following is the pop-up prompt of a successful

comparison result.

Other manuals for NGTeco NG-MB2