NG-MB1/NG-MB2 User Manual
Page | 66 Copyright©2022 NGTeco. All rights reserved.
Example: Assume that the duplicate punch period is 5 minutes. If you make
several check-in attendance punches within 5 minutes, the device considers only
the first punch time and ignores the rest of the attendance punches.
Auto Punch Mode: When this feature is enabled, the punch state will not be
displayed on the home screen and the punch state will be updated automatically
based on the previous punch state of the user. For example, if the user’s first
punch state is Check-in, then the next punch state is Check-out. This feature is
enabled by default.
Note: When the time exceeds the Day Cutoff Time, the punch state will be reset
to Check-in.
If the Auto Punch Mode is turned off, the user needs to select the punch state
manually and the punch state will be displayed on the home screen. Press the ☉
/< button to change the punch state to IN, and the <M/OK> button to change
the punch state to OUT. The punch state is Check-in by default and if the user
presses the <M/OK> button the state will change to Check-out for five seconds.
Then, the state will be auto-changed to Check-in.
View Punch Record: When this option is turned on, the users can view their
attendance records by themselves.
If the View Punch Record is turned off, the users cannot view the attendance
records.
11 Attendance Tracking
You can track and monitor the user's attendance to ensure productivity and workflow during
working hours.
11.1 Every Day's Attendance
The device is equipped with a provision to view the daily attendance of users. The steps to
view the daily attendance is given below:
To Next Page
Loading...
