NG-MB1/NG-MB2 User Manual
Page | 46 Copyright©2022 NGTeco. All rights reserved.
The following are the required parameters to set the date and time.
Manual Data and Time: Set date and time of the device.
24-Hour Time: Select whether to use the 24-hour display mode. If not, the 12-
hour display mode is adopted.
Date Format: Set the Date Format from the available options using <> or <>
key.
Daylight Saving: Enable or Disable the Daylight Saving using <M/OK> key.
After setting the parameters press <M/OK> to save the date and time.
7.2 Face Parameters
1. Go to [System] and press <M/OK>.
To Next Page
Loading...
