NGTeco NG-MB2 - Page 26

To Next Page

To Previous Page

NG-MB1/NG-MB2 User Manual

 ID: The User ID will be auto-generated beginning from 1. If you want to change

the User ID generated by the device, delete the displayed ID by pressing <M/OK>

and enter the new User ID.

 First Name: Enter the First Name of the user.

 Last Name: Enter the Last Name of the user. Refer T9 Mode

for further details.

 User Role: Set the User Role of the user as Employee/Admin. Press the <> or

<> key to select the User Role, and then press <M/OK>.

 Verification Mode: The available verification modes are:

Password/Fingerprint/Card/Face, Fingerprint only, User ID only, Password, Card

only, Fingerprint/Password, Fingerprint/Card, User ID + Fingerprint, Fingerprint +

Password, Fingerprint + Card, Fingerprint + Password + Card, Password + Card,

Password/Card, User ID + Fingerprint + Password, Fingerprint + (Card/User ID),

Face only, Face + Fingerprint, Face + Password, Face + Card, Face + Fingerprint +

Card, Face + Fingerprint + Password. (Note: "/" means "or", and "+" means "and".)

 Fingerprint: To enroll the fingerprint, press <M/OK>. The interface to enroll the

fingerprint will be displayed as shown below:

Other manuals for NGTeco NG-MB2