Description of functions - Expansion card 1
39
FIGHTER 1330
Quick guide - menu settings pool
Menu 9.1.5 Pool
Here pool heating is set either On or Off. The fac-
tory setting is Off.
Menu 6.5.1 Start temp. pool
Here you select at which pool temperature on the
sensor (PTG) heating should start. The value is
adjustable between 5 and 60 °C in increments of
0.5 °C. The factory setting is 22.0 °C.
Menu 6.5.2 Stop temp. pool
Here you select at which pool temperature on
the sensor (PTG) heating should stop. Adjustable
between 5 and 60 °C in increments of 0.5 °C. The
factory setting is 24.0 °C.
Menu 6.5.3 Periodtime heat/pool
The length of time is set here. The value is adjust-
able between 10 and 1000 minutes. The factory
setting is 100 minutes.
Menu 6.5.4 Max-time heatproduct
Here you select how much time of the period
time (menu 6.5.3) is to be used to heat the house
when there is a need of heating and pool heating.
The value is adjustable between 0 and 1000 min-
utes. The factory setting is 50 minutes.
Menu 6.5.5 Max compr. to pool
The maximum number of compressors that can
be operated towards the pool exchanger (VX-P)
is set here. The number of compressors that cur-
rently produce pool heat is within brackets. The
value can be adjusted between 0 and 18. Factory
setting is 1.
Menu 5.4.12 Pool heating compr. A
The menu is only displayed when pool is selected as
“On” in menu 9.1.5
If it is “On”, compr. A in the heat pump that is selected in
menu 5.1 is permitted to carry out pool heating.
Menu 5.4.13 Pool heating compr. B
The menu is only displayed when pool is selected as
“On” in menu 9.1.5
If it is “On”, compr. B in the heat pump that is selected in
menu 5.1 is permitted to carry out pool heating.
Pool
The outline diagram with docking instruc-
tions is available at www.nibe.com
To Next Page
Loading...
