Nibe FIGHTER 1330 - 4.0 Outdoor Temperature; 5.0 Heat Pump

Control
FIGHTER 1330
60
Menu 4.1 Medium outdoor temp.
The average outdoor temperature for the last 24
hours is shown here.
Menu 4.2 Return
Pressing the Enter button returns you to menu 4.0.
N
N
N
N
N
N
U
U
U
U
U
N
5.0 Heat pump
Menu 5.1 Heat pump unit
The heat pump unit is selected here, for which
submenus to menu 5.0 applies:
Master / Slave 1 / Slave 2 / ... / Slave 8.
Only activated units can be selected (menu 0.2).
Menu 5.2.0 Compressor module A
The current mode of compressor module A is
shown here:
”Heat / Hot water / Ext. control / Waiting / Alarm
/ Off”. Pressing the enter button takes you to the
sub-menus that show the temperatures and statis-
tics for compressor module A.
Menu 5.2.1 Heating flow/return
The internal flow (VBFA) and return temperatures
(VBRA) are shown here for the heat medium to the
compressor module A.
Menu 5.2.2 Brine in/out
The current incoming (KBinA) and outgoing tem-
perature (KButA) are shown here for brine to the
compressor module A.
Menu 5.2.3 Hot gas temperature
The current hot gas temperature for compressor
module A at the sensor (HGA) is shown here.
Menu 5.2.4 Overheating temp.
The current bulb temperature for compressor mod-
ule A at the sensor (BA) is shown here.
Menu 5.2.5 Liquide line temp..
The current fluid line temperature for compressor
module A at the sensor (VLA) is shown here.
Menu 5.2.6 Tot. starts compr. A
The number of times that compressor A has been
started since the first start up is shown here. The
value is saved in the microprocessor and thus is
not reset even when the heat pump is switched off
using the main power switch.
Menu 5.2.7 Opera.time compr. A
The number of hours that compressor A has been
in operation since the first start up is shown here.
The value is saved in the microprocessor and thus
is not reset even when the heat pump is switched
off using the main power switch.
Menu 5.2.8 Return
Pressing the enter button returns you to menu
5.2.0.
4.0 Outdoor temperature
Normal menus: displayed in all menu modes.
Extended menus: Only displayed when exten-
ded or service is selected in menu 8.1.1.
Service menus: Only displayed when service is
selected in menu 8.1.1.
U
S
N