Nibe FIGHTER 1330 - Control; General; Quick Movement; Screen Saver

Control
51
FIGHTER 1330
The menu tree shows all the menus. Three different
menu types can be chosen.
Normal, the menus the user needs for a quick
production control.
Extended, shows all menus except the service
menus.
Service, shows all menus. Returns to the previ-
ously selected menu type 30 minutes after the last
button was pushed.
Changing of menu type is done from menu 8.1.1
Information is provided on the display about the heat
pump's operating status. A screen saver is normally
shown on the display screen. The plus and minus but-
tons and the enter button can be used to scroll through
the menu system as well as to change the set value in
some menus.
The plus button is used to move forward to
the next menu on the current menu level
and to increase the value of the parameter
in menus where this is possible.
The minus button is used to move back to
the previous menu on the current menu
level and to decrease value of the param-
eter in menus where this is possible.
The enter button is used to select sub-
menus of the current menu, to permit
parameters to be changed and confirm any
changes to parameters. When the menu
number ends with “0” this indicates there is
a sub-menu.
N
U
S
General
To quickly return to the main menu from sub-menus
press the following:
■ Operating mode button
■ Enter button
Quick movement
NOTE!
Ensure the operating mode is not
changed during quick movement.
A key lock can be activated in the main menus by
simultaneously pressing the plus and the minus but-
tons. The key symbol will then be shown on the dis-
play. The same procedure is used to deactivate the
key lock.
Key lock
A B I II
50.0 C
Hotwatertemperature
13.43
1.0
A B
Menu name
Menu number
Key lock
Clock
Symbols
Value of the cur-
rent parameter
In screen saver mode, you can see any alarms as
well as the flow temperatures currently given by the
compressors (VBFA and VBFB) and whether the heat
pump is a Master or Slave. The screen saver is deac-
tivated by pressing the enter button and the but-
ton in the lower left for approximately 8 seconds.
Menu 1.0 is then displayed. The screen saver comes
on automatically 30 minutes after the last button was
pressed and when starting the heat pump.
Example:
54.1 55.7 °C
Slave 3
HP-ALARM
Slave 3
alt.
Screen saver