EasyManua.ls Logo

Nibe FIGHTER 360P - Installer Setup and Technical Information; Transport, Handling, and Storage

Nibe FIGHTER 360P
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
For the Installer
FIGHTER 360P
For the Installer
10
2
1 3
0
4
2
1
3
0
4
2
1
3
04
?
Här är pluggen (61)
bortskruvad. Används i
MAV Extra shunt.
LEK
LEK
LEK
LEK
LEK
NOTE!
Work on the refrigerant system must be
done by authorised personnel in
accordance with the relevant legislation
on refrigerants, supplemented by
additional requirements for flammable
gas, for example, product knowledge as
well as service instruction on gas
systems with flammable gases.
FIGHTER 360P should be transported and stored ver-
tically in the dry. The FIGHTER 360P may however be
carefully laid on its back when being moved into a
building.
The heat pump contains highly inflam-
mable refrigerant. Special care should be
exercised during handling, installation,
service, cleaning and scrapping to avoid
damage to the refrigerant system and in
doing so reduce the risk of leakage.
Transport and storage
Handling
NOTE!
The transport guard around the compressor
must be removed before starting.
The lifting straps on top of the heat pump should be
removed before starting as these can otherwise cause
increased sound levels. These are removed by first
cutting with a knife and then pulling them out.
Lifting straps
LEK
12

Table of Contents

Related product manuals