Nice MOONCLEVER MC424

To Next Page

To Previous Page

12 – English

Remote memorising

It is possible to enter a new transmitter in the receiver memory without using

the keypad. A previously memorised and operational remote control must be

available.Thenewtransmitterwill“inherit”thecharacteristicsofthepreviously

memorisedone.Therefore,ifthersttransmitterismemorisedinmodeI,the

new one will also be memorised in mode I and any of the buttons of the trans-

mittercanbepressed.IfthersttransmitterismemorisedinmodeIIthenew

one will also be memorised in mode II but the button activating the required

outputmustbepressedonthersttransmitterasmustthebuttonrequiredto

bememorisedonthesecond.Youneedtoreadalltheinstructionsinadvance

so you can perform the operations in sequence without interruptions. Now,

withthetworemotecontrols(theNEWonerequiringcodememorisationand

theOLDonethatisalreadymemorised),positionyourselfwithintheoperating

rangeoftheradiocontrols(withinmaximumrange)andcarryouttheinstruc-

tions listed in the table.

All the memorised codes can be deleted as follows:

DELETING ALL TRANSMITTERS

TECHNICAL CHARACTERISTICS OF THE PRODUCT

Receivers: SMXI SMXIS

Decoding Rollingcode52bitFLOR Rolling code 64bitSMILO

Transmitter compatibility FLOR,VERYVR,NICEWAY,ERGO,PLANO,NICEONE SMILO

Frequency 433.92 MHz 433.92 MHz

Input impedance 52KΩ 52KΩ

Outputs 4 (on SM connector) 4(on SM connector)

Sensitivity better than 0.5µV better than 0.5µV

Working temp. from-10°Cto+55°C from-10°Cto+55°C

Transmitters: FLO2R SMILO

Buttons 1,2or 4 according to the versions 2 or 4

Power input 12V

Batt.23A 12V Batt. 23 A

Absorption 10mA 25mA

Transmission frequency 433.92 MHz 433.92 MHz

Working temp. from-10°Cto+55°C from-10°Cto+55°C

Radiated power estimatedapproximately1mWE.R.P. estimatedapproximately1mWE.R.P.

Range estimated200m(outdoors);35m(indoors) estimated200m(outdoors);35m(indoors)

Dimensions / Weight 69x39x15,5mm/31g. Ø48mmxH14mm-14g

Encoding digital(4.5x10

combinations) digital(18x10

combinations)

WARNINGS:•Alltechnicalcharacteristicsstatedrefertoanambienttemperatureof20°C(±5°C).•NiceS.p.areservestherighttomodifytheproductatany

timee,whilemaintainingthesamefunctionalitiesandintendeduse.•Therangeofthetransmittersandthereceptioncapacityofthereceiversmaybesubjectto

interference that may alter their performance. In the event of interference, Nice cannot guarantee the effective capacity of their devices.

TABLE B3 - Remote Memorising

01. PressthebuttonontheNEWtransmitterforatleast5secondsandthenrelease

02. PressthebuttonontheOLDtransmitter3timesslowly

03. PressthebuttonontheNEWtransmitterslowlyandthenrelease

Note – If there are other transmitters to memorise, repeat the above steps for each new transmitter.

TX TX

1s1s

x5s

TABLE B4 - Deleting all transmitters

01. Press the receiver button and hold it down

02. WaitfortheLedtolightup,thenwaitforittoswitchoffandthenwaitforittoash3times