Nice Robus RBS400 - Deleting a Radio Command; Deleting a Single Command Associated with a Button from the Receivers Memory; Deleting the Receivers Memory (Fully)

ENGLISH – 29
7.4 DELETING A RADIO COMMAND
7.4.1 DELETING A SINGLE COMMAND ASSOCIATED WITH A BUTTON FROM THE RECEIVER’S MEMORY
During the execution of the procedure indicated in “Table 15” it is possible to delete the memorisation of a command associated with a button
a
Warning! If the transmitter is memorised in “Mode 1” (refer to the “Memorisation in “Mode 1”” paragraph), during the pro-
cedure the entire transmitter is deleted, in other words, all buttons of the radio remote control.
Table 15
DELETING A SINGLE BUTTON FROM THE RECEIVER’S MEMORY
Description Symbols used
Press and hold the “Radio” button on the control unit and wait for LED “R”
to light up green and switch off. Release the “Radio” button
On the transmitter to be deleted
If one-way, press and hold button (*4) to be deleted and release it only
once LED “R” on the control unit has emitted the 1st of 5 fast green
ashes (=memorisation completed correctly).
If two-way, press and release the button to be deleted (*4); LED “R”
on the control unit will emit 5 fast green ashes (=deletion completed
successfully).
(*4) - If the transmitter is memorised in “Mode 1” (see “Memorisation in “Mode 1””), any button can be pressed. If the transmitter is memorised in
“Mode 2” (see “Memorisation in “Mode 2””), the entire procedure must be repeated for each memorised button that must be deleted.
7.4.2 DELETING THE RECEIVER’S MEMORY (FULLY)
In a one-way system, the code deletion procedures involve the receiver alone. In a two-way system, it will instead be necessary to delete the pairing
also on the radio remote control.
To perform this procedure, consult the instruction manual of the relevant transmitter.
Table 16
FULL DELETION OF THE RECEIVER’S MEMORY.
Description Symbols used
Press and hold the “Radio” button on the control unit and wait for LED “R” to
light up green and switch off. It will start ashing after a few seconds.
---
Deletion modes
To delete the receiver’s memory, release the “Radio” button precisely at the
5th ash.
Wait for LED “R” on the control unit to make 5 rapid ashes. (Deletion
completed successfully).