ENGLISH – 31
PROGRAMMING THE CONTROL UNIT
8
8 PROGRAMMING THE CONTROL UNIT
There are 3 buttons on the control unit:
f
,
g
and
h
(“Figure 50”) which can be used both to command the control
unit and to programme the available functions.
Aerial
50
The available programmable functions are grouped into two levels and
their operating status is signalled by eight LEDs “L1 ... L8” located on the
control unit (LED lit = function enabled; LED off = function disabled).
8.1 USING THE PROGRAMMING BUTTONS
f
The button can be used to command the automation’s opening move-
ment, or to shift the programming point upwards.
g
Button used to stop a manoeuvre.
If pressed for more than 3 seconds, it allows for entering the programming
mode.
h
The button enables the user to close the automation or shift the program-
ming point downwards.
a
Warning! During the manoeuvre, whether opening or
closing is irrelevant, all the buttons perform the STOP
function and stop the motor’s movement.
To Next Page
Loading...
