Nice Robus RBS400 - Page 4

4 – ENGLISH
– If the opening movement is controlled by a re-sensing system,
make sure that any windows larger than 200 mm are closed
using the control elements.
– Prevent and avoid any form of entrapment between the moving
and xed parts during the manoeuvres.
– Permanently afx the label concerning the manual manoeuvre
near its actuating element.
– After installing the drive motor, make sure that the mechanism,
protective system and all manual manoeuvres function properly.
– Doors and vertical gates require an anti-fall function or device
– For drive motors that allow for accessing unprotected moving
parts once they have been installed, such parts must be in
-
stalled at least 2.5 m above the oor or other surface from which
they can be accessed.
– Make sure to avoid any entanglements due to the opening
movement of the driven part.
– After the installation, make sure that the mechanism is correctly
adjusted and that the protection system and the manual release
device (if present) work properly.
Battery-operated appliances
– The appliance must be disconnected from the power supply
when removing the batteries.
– The batteries must be removed from the appliance prior to its
disposal.
– The batteries must be safely disposed of.
– If the batteries are not rechargeable, do not replace them with
rechargeable batteries.
Appliances with LED light
– Looking at LED lights from close up and for prolonged periods
can cause dazzling. It may temporarily reduce eyesight and
cause accidents.
– Avoid looking at LEDs directly.
Appliances with radio device
– The manufacturer of this appliance, Nice S.p.A., hereby declares
that the product complies with Directive 2014/53/EU.
– The instruction manual and the full text of the EU Declaration
of Conformity are available at the following Internet address:
www.niceforyou.com, under the “support” and “download” sec
-
tions
– For transmitters: 433 MHz: ERP < 10 dBm - 868 MHz: ERP <
14 dBm; for receivers: 433 MHz, 868 MHz.