Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
Installation and System Design Guide 37
Issue Number: 1
Installing the first option module
• Move the option module in direction shown (1).
• Align and insert the option module tab in to the slot provided (2), this is highlighted in the detailed view (A).
• Press down on the option module until it clicks into place.
Installing the second option module
• Move the option module in direction shown (3).
• Align and insert the option module tab in to the slot provided on the already installed option module (4), this is highlighted in the detailed view (B).
• Press down on the option module until it clicks into place. Image (5) shows two option modules fully installed.
Installing the third option module
• Repeat the above process.
The drive has the facility for all three option module slots to be used at the same time, image (6) shows the three option modules installed.
Figure 3-5 Removal of a standard option module
• Press down on the tab (1) to release the option module from the drive housing, the tab is highlighted in the detailed view (A).
• Tilt the option module towards you as shown (2).
• Totally remove the option module in direction shown (3).
Figure 3-6 Installation and removal of a large option module
To Next Page
Loading...
