Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
38 Installation and System Design Guide
Issue Number: 1
Installing a large option module
• Move the option module in direction shown (1).
• Align and insert the option module tabs A) into the slot provided (B).
• Press down on the option module until it clicks into place.
Removing a large option module
• Press down on the tab (2C), tilt the option module towards you and remove..
The large option module can only be inserted into slot 3. Additional standard option modules can still be installed and used in slot 2 and slot 1.
Figure 3-7 Installation and removal of the KI-Remote Keypad RTC
• To install, align the keypad and press gently in the direction shown until it clicks into position.
• To remove, reverse the installation instructions.
Figure 3-8 Connection of the KI-Remote Keypad RTC
1. KI-485 Adaptor
2. RJ-485 lead
3. Remote keypad (KI-Remote Keypad RTC)
N
The keypad options can be installed / removed while the drive is powered up and running a motor.
To Next Page
Loading...
