8 Installation and System Design Guide
Issue Number: 1
DoC authorised by:
G. Williams
Vice President, Technology
Date: 6th September 2017
Place: Newtown, Powys, UK
IMPORTANT NOTICE
These electronic drive products are intended to be used with appropriate motors, controllers, electrical protection components and other
equipment to form complete end products or systems. It is the responsibility of the installer to ensure that the design of the complete
machine, including its safety-related control system, is carried out in accordance with the requirements of the Machinery Directive and any
other relevant legislation. The use of a safety-related drive in itself does not ensure the safety of the machine. Compliance with safety and
EMC regulations depends upon installing and configuring drives correctly, including using the specified input filters. The drive must be
installed only by professional installers who are familiar with requirements for safety and EMC. The assembler is responsible for ensuring
that the end product or system complies with all relevant laws in the country where it is to be used. For more information regarding Safe
Torque Off, refer to the Product Documentation.
To Next Page
Loading...
Need help?
General