NKT Photonics SUPERK SELECT - Figures

11
FIGURES
Figure 1: SuperK SELECT with dual AOTF outputs – general view ......................... 15
Figure 2: SuperK SELECT standard dual RF driver system view ..............................17
Figure 3: Primary output shutters – VIR/NIR set open and NIR/IR set closed ..... 18
Figure 4: Top panel .............................................................................................................. 19
Figure 5: Optical Interfaces ............................................................................................... 21
Figure 6: Optical Interfaces .............................................................................................. 22
Figure 7: Electrical Interfaces ad optical input ............................................................. 23
Figure 8: External RF Driver unit – general view ........................................................ 24
Figure 9: External RF Driver – rear panel ..................................................................... 25
Figure 10: SELECT Status LEDs ........................................................................................27
Figure 11: Side panel manufacturing label .................................................................... 28
Figure 12: Top panel labels ............................................................................................... 29
Figure 13: Partially inserting the collimator ................................................................... 32
Figure 14: Collimator alignment key and slot ............................................................... 32
Figure 15: Collimator lock screw .................................................................................... 33
Figure 16: Connecting a SELECT - single ERD ............................................................ 34
Figure 17: Connecting single ERDs ................................................................................. 34
Figure 18: Bus defeater ...................................................................................................... 34
Figure 19: Setting External bus addresses - single ERD system ............................. 35
Figure 20: Connecting a SELECT - dual ERD .............................................................. 36
Figure 21: Connecting dual ERDs .................................................................................... 36
Figure 22: Setting External bus addresses - dual ERD system ................................37
Figure 23: Spectral output of a single AOTF channel ............................................... 39
Figure 24: AOTF transmission spectrum for varying RF powers ............................ 40
Figure 25: Optical power for a specific wavelength as a function of RF power .. 41
Figure 26: Wavelength versus optimum RF power level ........................................... 41
Figure 27: CONTROL panel navigation ......................................................................... 43
Figure 28: Device selector icon ....................................................................................... 44