Boot Options
152
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
4.6 OOB Ethernet Management Port
The 7210 SAS platforms support the OOB Ethernet management port for
management of the node. An OOB Ethernet port can be used to download the
TiMOS image file and the configuration file by creating a BOF manually. The OOB
management port allows for use of both IPv4 and IPv6. See IPv6 Configuration
Guidelines in OOB Node Management for information about platforms that support
IPv6 for the OOB management port.
Refer to the 7210 SAS OS Software Release Notes 11.0Rx for information about the
specific software release that supports OOB management port and IPv6.
4.6.1 IPv6 Configuration Guidelines in OOB Node
Management
The following are the configuration guidelines for IPv6 on an OOB management port
of the node.
• The management port on the management router instance only supports host
functionality.
• It is required that an IPv4 address is configured in the BOF. A BOF that contains
only IPv6 addresses is not supported.
• IPv6 duplicate address detection is not supported.
• IPv6 auto-configuration is not supported.
• IPv6 over IPv4 tunneling is not supported.
• IPv6 path MTU discovery is not supported.
• The router discovery option is not supported on the management port.
4.7 Security for Console Port and Ethernet
Management Port
The 7210 SAS OS supports disabling the console port and OOB Ethernet
management port. In remote deployments, operators can choose to disable user
access to the node through the console and through the Ethernet management port
to prevent unauthorized and malicious access. Use the bof>console-disabled
command to disable the console and the bof>eth-mgmt-disabled command to
disable the use of the Ethernet management port.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
