7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
181
Example: A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
Use the following command syntax to save the system configuration.
CLI Syntax: admin# save [file-url] [detail] [index]
Example: A:ALA-1# admin save cf1:\test123.cfg
Saving config.# Saved to cf1:\test123.cfg
... complete
A:ALA-1#
4.11.1.3 Deleting BOF Parameters
You can delete specific BOF parameters. The no form of these commands removes
the parameter from configuration. The changes remain in effect only during the
current power cycle unless a save command is executed. Changes are lost if the
system is powered down or the router is rebooted without saving.
Deleting the BOF and rebooting causes the system to enter the auto mode.
Use the following CLI syntax to save and remove BOF configuration parameters.
CLI Syntax: bof# save [cflash-id]
Example: A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
CLI Syntax: *A:7210>bof#
no console-speed
no dns-domain
no eth-mgmt-address
no eth-mgmt-autoneg
no eth-mgmt-disable
eth-mgmt-duplex
no eth-mgmt-route
Note: If the persist option is enabled and the admin save file-url command is executed with
an FTP path used as the file-url parameter, two FTP sessions simultaneously open to the
FTP server. The FTP server must be configured to allow multiple sessions from the same
login; otherwise, the configuration and index files will not be saved correctly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
