Nokia 7210 - Configuring a System Resource Profile for a VC

Virtual Chassis
234
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
5.5 Configuring a System Resource Profile for a
VC
A node system resource profile is divided into two parts:
• a global resource profile to manage the VC-wide resources for certain features
• a resource profile per card/slot to manage the resources on a specific slot
The per card/slot resource profile is useful for allocating resources to different
features on each card to suit the application or service being delivered on those
access ports.
The following output is an example of the per-node global system resource profile for
a VC.
A:Dut-A# configure system global-res-profile
A:Dut-A>config>system>glob-res# info detail
----------------------------------------------
router
no ecmp
no ldp-ecmp
no max-ip-subnets
no max-ipv6-routes
exit
----------------------------------------------
A:Dut-A>config>system>glob-res#
The following output shows an example of the per-card/slot resource profile for a VC.
*A:Dut-A# configure system resource-profile 1
*A:Dut-A>config>system>res-prof# info detail
----------------------------------------------
description "Default System Resource Profile Policy"
no g8032-control-sap-tags
ingress-internal-tcam
sap-aggregate-meter 2
qos-sap-ingress-resource 4
mac-match-enable 6
ipv4-match-enable 6
ipv6-ipv4-match-enable 6
ipv4-mac-match-enable 6
exit
acl-sap-ingress 2
ipv4-match-enable 5
ipv6-64-only-match-enable 5
ipv4-ipv6-128-match-enable 5
mac-match-enable 5
exit
eth-cfm 2
no up-mep
sap-down-mep 1
sdp-down-mep-ing-mip 1