Nokia 7210 - Debug Commands

System Management
680
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
bits1 — Clears the BITS1 port reference. This keyword is only supported on
7210 SAS-Mxp, 7210 SAS-T, 7210 SAS-R6 and 7210 SAS-R12 platforms.
bits2 — Clears the BITS2 port reference. This keyword is only supported on 7210 SAS-T
and 7210 SAS-Mxp platforms.
trace
Syntax trace log
Context clear
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command allows an operator to clear the trace log.
6.12.2.4 Debug Commands
sync-if-timing
Syntax sync-if-timing
Context debug
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context debug synchronous interface timing references.
force-reference
Syntax force-reference {ref1 | ref2 | bits1 | bits2 | ptp}
no force-reference
Context debug>sync-if-timing
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode; not supported on platforms configured in the
satndalone-VC operating mode
Description This command forces the system synchronous timing output to use a specific reference.