7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
543
ipv6-64-only-match-enable
Syntax ipv6-64-only-match-enable num-resources
no ipv6-64-only-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by ingress filter policies using ipv6
criteria with 64-bit IPv6 addresses. Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Router
Configuration Guide for more information on resource allocation and fields available for use.
The resources cannot be shared with IPv4 filter policies or IPv6 filter policies specifying 128-
bit addresses.
Ingress ACL resources are shared with SAP ingress aggregate meter. See the sap-
aggregate-meter command for more information.
7210 SAS-T access-uplink mode (per
node)
07 max
7210 SAS-T network mode (per node) 0 6 max
7210 SAS-R6 (per IMMv1) 0 7 max
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
012 max
7210 SAS-R6 and 7210 SAS-R12 (per
IMM-c)
010 max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node)
(standalone)
07 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 6 max
7210 SAS-S 1/10GE (per node)
(standalone)
07 max
7210 SAS-S 1/10GE (standalone-VC) 0 6 max
7210 SAS-Sx 10/100GE (per node) 0 3 max
Table 54 Number of Resources Available for IPv4-Match-Enable
Platforms Min value
(per node)
Max value (per
node)
Default
Values
To Next Page
Loading...
