Nokia 7210 - Page 542

System Management
542
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
ipv4-match-enable
Syntax ipv4-match-enable num-resources
no ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by SAP ingress QoS policies using IPv4
criteria (any).
The resource cannot be shared with SAP ingress QoS filter policies using mac criteria or ipv6
criteria. Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Quality of Service Guide for more
information on resource allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for
use by SAP ingress QoS policies using ipv4 criteria. If no resources are allocated for use, the
software fails all attempts to associate a service entity (for example, SAP and IP interface)
with a SAP ingress QoS policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter
match criteria.
If the user specifies max, the software allocates one chunk when the first SAP is
associated with a SAP ingress QoS policy using this match criteria. It continues to
allocate resources to SAPs associated with a SAP ingress QoS policy using this
criteria, as long as the total amount of resources allocated does not exceed the
resources allocated to SAP ingress QoS policies (configured with the config system
resource-profile ingress-internal-tcam qos-sap-ingress- resource command)
and chunks are available for use.
Values Table 54 lists the parameter values.
7210 SAS-Sx 10/100GE (per node) 0 4 max
Table 53 Number of Resources Available for IPv4-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
Table 54 Number of Resources Available for IPv4-Match-Enable
Platforms Min value
(per node)
Max value (per
node)
Default
Values
7210 SAS-M (per node) 0 10 max