System Management
318
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
- when the card/IMM is provisioned and equipped, but there is a mismatch
between the two
• Upon provisioning the card, subsequent to attaching a new system-resource
policy, the parameters specified in the policy are used (including any boot-time
parameters).
• If the card is provisioned and equipped, and any boot-time parameter is changed
in the system-resource policy, the user must issue the card reset command for
all cards that are using the policy or reboot the chassis, for the policy change to
take effect.
6.9 System Configuration Process Overview
Figure 35 shows the process to provision basic system parameters.
Figure 35 System Configuration and Implementation Flow
6.10 Configuration Notes
This section describes system configuration caveats.
To access the CLI, ensure that the 7210 SAS device is properly initialized and the
boot loader and BOFs have successfully executed.
sw0685
Start
Configure Time Parameters
Configure System Information
End
To Next Page
Loading...
