7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
CLI Usage
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
55
2.9.2.1 Global Commands
enable-admin
Syntax enable-admin
Context <global>
Description
The enable-admin command is in the default profile. By default, all users are given access
to this command.
When the enable-admin command is entered, the user is prompted for a password. If the
password is correct, the user is given unrestricted access to all commands.
The minimum length of the password is determined by the minimum-length command. The
complexity requirements for the password is determined by the complexity command.
The following is an example of a password configuration.
A:ALA-1>config>system>security# info
----------------------------------------------
...
password
aging 365
minimum-length 8
attempts 5 time 5 lockout 20
admin-password "rUYUz9XMo6I" hash
exit
...
----------------------------------------------
A:ALA-1>config>system>security#
Use one of the following options to verify that a user is in the enable-admin mode.
• Administrators cab use the show users command to know which users are in this mode.
• Enter the enable-admin command again at the root prompt and an error message will
be returned.
The following is an example output for the show users command.
A:ALA-1# show users
===============================================================================
User Type From Login time Idle time
===============================================================================
admin Console -- 10AUG2006 13:55:24 0d 19:42:22
Note: See the description for the admin-password command. If the admin-password is
configured in the config>system>security>password context, any user can enter a
special administrative mode by entering the enable-admin command.
To Next Page
Loading...
