7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Virtual Chassis
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
229
iv. specify the slot number and MAC address for CPM A and CPM B in the
vc-stack-node parameter
v. specify the IP prefix information for the active and standby options in
the eth-mgmt-address parameter
Step 6. Configure other BOF parameters such as image location, configuration file
location, and route information, similar to a 7210 node operating in the
standalone mode. See System Boot Options for 7210 SAS-Mxp,
7210 SAS-S 1/10GE, 7210 SAS-Sx 1/10GE, and 7210 SAS-Sx 10/100GE
in Standalone Mode for information.
You can get the TiMOS image (both.tim) for the CPM-IMM nodes from the local SD
card or through the network by specifying the primary/secondary/tertiary image
locations appropriately.
The following output is an example of a CPM-IMM node configuration.
A:Dut-A# show bof
========================================================================
BOF (Memory)
========================================================================
primary-image ftp://*:*@135.250.127.36/./images/7xxx-hops/
primary-config cf1:\default.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.17.166/24 active
eth-mgmt-address 10.135.17.167/24 standby
eth-mgmt-route 10.250.0.0/16 next-hop 10.135.17.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-name VC-3
vc-stack-node-type cpm-imm
vc-stack-node cpmA slot-num 1 mac-addr d0:99:d5:91:1c:41
vc-stack-node cpmB slot-num 2 mac-addr d0:99:d5:90:1e:41
=======================================================================
5.2.3 Manually Booting a VC IMM-Only Node
The IMM-only node can be booted independently of the CPM-IMM nodes. Perform
the following steps to manually configure IMM-only nodes in a VC.
Step 1. To boot the IMM-only node, use the SD card provided with the software
license that contains the appropriate boot.tim image.
To Next Page
Loading...
